"Evaluation of Friction in Orthodontics Using Various Brackets and Archwire Combinations-An in Vitro Study”
Published: May 1, 2014 | DOI: https://doi.org/10.7860/JCDR/2014/.4364
Sujeet Kumar, Shamsher Singh, Rani Hamsa.P.R, Sameer Ahmed, Prasanth MA., Apoorva Bhatnagar, Manreet Sidhu, Pramod Shetty
1. Senior Lecturer, Department of Orthodontics, Vyas Dental College and Hospital, Jodhpur, India.
2. Reader, Department of Pedodontics and Preventive Dentistry, Vyas Dental College and Hospital, Jodhpur, India.
3. Professor, Department of Orthodontics, Vyas Dental College and Hospital, Jodhpur, India.
4. Senior Lecturer, Department of Periodontology, Vyas Dental College and Hospital, Jodhpur, India.
5. Professor and Head, Department of Pedodontics and Preventive Dentistry, Vyas Dental College and Hospital, Jodhpur, India.
6. PG Student, Conservative Dentistry & Endodontics, Pacific Dental College & Hospital, Udaipur, Rajasthan, India.
7. PG Student, Department of Orthodontics, Vyas Dental College and Hospital, Jodhpur, India.
8. Professor, Department of Orthodontics, Pacific Dental College and Hospital, Udaipur, Rajasthan, India.
Correspondence
Dr. Shamsher Singh,
Reader, Department of Pedodontics and Preventive Dentistry, Vyas Dental College and Hospital, Jodhpur, India.
Phone: 9462601710, E-mail: docshamsher@gmail.com
AIM: The aim of this study was to compare frictional resistance which was produced between conventional brackets (0.022 slot Otho-Organiser) and self ligating brackets (active Forestadent and passive Damon III) by using various arch wire combinations (0.016 Niti, 0.018 Niti, 0.017 x 0.025 SS and 0.019 x 0.025 SS).
Materials and Methods: An experimental model which consisted of 5 aligned stainless steel 0.022-in brackets was used to assess frictional forces which were produced by SLBs (self ligating brackets) and CELs (conventional elastomeric ligatures) with use of 0.016 nickel titanium, 0.018 nickel titanium, 0.017 X 0.025”stainless steel and 0.019 X 0.025”stainless steel wires.
Statistical Analysis: One way ANOVA test was used to study the effect of the bracket type, wire alloy and section on frictional resistance test . Results: Conventional brackets produced highest levels of friction for all bracket/archwire combinations. Both Damon III and Forestadent brackets were found to produce significantly lower levels of friction when they were compared with elastomerically tied conventional brackets.
Conclusion: SLBs are valid alternatives for low friction during sliding mechanics.
[
FULL TEXT ] | [ PDF]